This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
featherchorder [2016/02/21 21:09] priestdo |
featherchorder [2016/02/21 21:10] priestdo |
||
---|---|---|---|
Line 21: | Line 21: | ||
{{https://github.com/clc/chorder|https://github.com/clc/chorder}} | {{https://github.com/clc/chorder|https://github.com/clc/chorder}} | ||
</box|Thanks to Charles Chen for his work on this version! > | </box|Thanks to Charles Chen for his work on this version! > | ||
+ | |||
Line 31: | Line 32: | ||
- an adafruit feather 32u4 bluefruit | - an adafruit feather 32u4 bluefruit | ||
- | - 7 keyswitches, I suggest Cherry Red MX switches((I still put in lighter springs, but the reds are the best switch with which to start.)) | + | - 7 keyswitches; I suggest Cherry Red MX switches((I still put in lighter springs, but the reds are the best switch with which to start.)) |
- a small SPDT switch | - a small SPDT switch | ||
- | - a LiPo battery with 2-pin JST-PH connector, I like 350mA, 500mA is probably overkill. | + | - a LiPo battery with 2-pin JST-PH connector; I like 350mA, 500mA is probably overkill. |
- something to hold your keys, see other sections of this site for case ideas. It will work with the [[:3d_printer_files]]. | - something to hold your keys, see other sections of this site for case ideas. It will work with the [[:3d_printer_files]]. | ||