Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
spiffchorder:2010-03-leather [2010/03/21 17:06]
priestdo
spiffchorder:2010-03-leather [2010/03/21 17:08]
priestdo
Line 6: Line 6:
 |{{spiffchorder:​2010.03.lc.ip.jpg?​400|}}| as tested prior to final glue up (Don't glue the case closed before you know it all works!)| |{{spiffchorder:​2010.03.lc.ip.jpg?​400|}}| as tested prior to final glue up (Don't glue the case closed before you know it all works!)|
 |{{spiffchorder:​2010.03.lc.keys.jpg?​400|}}|Underside of the plastic board with keyswithches all wired| |{{spiffchorder:​2010.03.lc.keys.jpg?​400|}}|Underside of the plastic board with keyswithches all wired|
-|{{spiffchorder:​2010.03.lc.electronics_top.jpg?​400|}}|circuit - board has been cut away to fit in to the case.  Since switches are close, no pullup resistors are used in this build|+|{{spiffchorder:​2010.03.lc.electronics_top.jpg?​400|}}|circuit - board has been cut away to fit in to the case.  Since switches are close, no pullup resistors are used in this build.  Keyswitches are wired to an eight pin sip socket ​|
 |{{spiffchorder:​2010.03.lc.electronics_bottom.jpg?​400|}}|underside of circuit - as you can see, only a few jumpers are needed| |{{spiffchorder:​2010.03.lc.electronics_bottom.jpg?​400|}}|underside of circuit - as you can see, only a few jumpers are needed|
 |{{spiffchorder:​2010.03.lc.assembly_01.jpg?​400|}}|foam keeps the keyswitch wire from contacting the circuit board| |{{spiffchorder:​2010.03.lc.assembly_01.jpg?​400|}}|foam keeps the keyswitch wire from contacting the circuit board|
spiffchorder/2010-03-leather.txt ยท Last modified: 2010/03/23 21:30 by priestdo
Top of the Wiki www.chimeric.de Creative Commons License Valid CSS Driven by DokuWiki Recent changes RSS feed Valid XHTML 1.0