Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
spiffchorder:2010-03-leather [2010/03/21 17:06] priestdo |
spiffchorder:2010-03-leather [2010/03/21 17:10] priestdo |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== March 2010 Leather Desktop Chorder ====== | ====== March 2010 Leather Desktop Chorder ====== | ||
| - | Sunday afternoon project. This one uses the atmega168 chip. It is built on a Radio Shack 276-150 printed circuit board which greatly reduces the need to run wires around. It uses cherry keyswithches with replacement lighter weight springs. It was used to create and edit this wiki page. | + | Sunday afternoon project. This right hand chorder uses the atmega168 chip. It is built on a Radio Shack 276-150 printed circuit board which greatly reduces the need to run wires around. It uses cherry keyswithches with replacement lighter weight springs. It was used to create and edit this wiki page. |
| -Greg | -Greg | ||
| Line 6: | Line 6: | ||
| |{{spiffchorder:2010.03.lc.ip.jpg?400|}}| as tested prior to final glue up (Don't glue the case closed before you know it all works!)| | |{{spiffchorder:2010.03.lc.ip.jpg?400|}}| as tested prior to final glue up (Don't glue the case closed before you know it all works!)| | ||
| |{{spiffchorder:2010.03.lc.keys.jpg?400|}}|Underside of the plastic board with keyswithches all wired| | |{{spiffchorder:2010.03.lc.keys.jpg?400|}}|Underside of the plastic board with keyswithches all wired| | ||
| - | |{{spiffchorder:2010.03.lc.electronics_top.jpg?400|}}|circuit - board has been cut away to fit in to the case. Since switches are close, no pullup resistors are used in this build| | + | |{{spiffchorder:2010.03.lc.electronics_top.jpg?400|}}|circuit - board has been cut away to fit in to the case. Since switches are close, no pullup resistors are used in this build. Keyswitches are wired to an eight pin sip socket | |
| |{{spiffchorder:2010.03.lc.electronics_bottom.jpg?400|}}|underside of circuit - as you can see, only a few jumpers are needed| | |{{spiffchorder:2010.03.lc.electronics_bottom.jpg?400|}}|underside of circuit - as you can see, only a few jumpers are needed| | ||
| |{{spiffchorder:2010.03.lc.assembly_01.jpg?400|}}|foam keeps the keyswitch wire from contacting the circuit board| | |{{spiffchorder:2010.03.lc.assembly_01.jpg?400|}}|foam keeps the keyswitch wire from contacting the circuit board| | ||
