Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
spiffchorder:sample_layout [2008/05/21 14:50]
priestdo
spiffchorder:sample_layout [2008/05/21 14:51] (current)
priestdo
Line 16: Line 16:
 Component names and numbers match those used on the [[hardware]] page. Component names and numbers match those used on the [[hardware]] page.
 </​columns>​ </​columns>​
 +
  
  
Line 61: Line 62:
 |14|  C4  |15|orientation is significant| |14|  C4  |15|orientation is significant|
  
-** Warning ** I have not yet wired up the wirewrap board, once I have (and as such confirmed that the wire chart below is correct) I will remove this warning -Greg+** Warning ** //I have not yet wired up the wirewrap board, once I have (and as such confirmed that the wire chart below is correct)// I will remove this warning -Greg
  
 Next use a wirewrap tool to connect the pairs of pins indicated in Chart Two.  Consider your final placement of the sockets and make your lines long enough to accommodate.  With this layout you could place a small amount of non conductive material between the sockets and place them bottom side to bottom side once you have tested the circuit and trimmed the long pins on the sockets. **Remember to take into account that you are turning the socket upside down when you wrap**. Check your pin numbers carefully. Check off the boxes in the first column when you wrap them, check off the third column when you confirm the wiring with a continuity meter. You may find it helpful to use a little double sided tape to hold the sockets down to your work surface while wirewrapping. I will post photos with labels once I make this version of the chorder. ​ Next use a wirewrap tool to connect the pairs of pins indicated in Chart Two.  Consider your final placement of the sockets and make your lines long enough to accommodate.  With this layout you could place a small amount of non conductive material between the sockets and place them bottom side to bottom side once you have tested the circuit and trimmed the long pins on the sockets. **Remember to take into account that you are turning the socket upside down when you wrap**. Check your pin numbers carefully. Check off the boxes in the first column when you wrap them, check off the third column when you confirm the wiring with a continuity meter. You may find it helpful to use a little double sided tape to hold the sockets down to your work surface while wirewrapping. I will post photos with labels once I make this version of the chorder. ​
spiffchorder/sample_layout.txt · Last modified: 2008/05/21 14:51 by priestdo
Top of the Wiki www.chimeric.de Creative Commons License Valid CSS Driven by DokuWiki Recent changes RSS feed Valid XHTML 1.0